To install the floppy drive first take out the front panel, The panel that is highlighted in the picture below.
Once that is out slot the floppy drive in and screw it to the case from the side. Shown below
Make sure the floppy drive is firmly connected to the case and does not move. Then locate the floppy ribbon cable and connect one end to the back of the floppy drive, and the other end to the motherboard (Shown Below)
Locate one of the 4-pin floppy drive connectors from the cases power supply. These are smaller flat style connectors compared to the larger 4-pin Molex style. Attach this to the floppy drive (Show below)
0 comments:
Post a Comment